An Investigation on the Wear and Corrosion Behavior of HVOF-Sprayed WC-12Co-Al2O3 Cermet Coating
Sign Up to like & getrecommendations! Published in 2018 at "Journal of Materials Engineering and Performance"
DOI: 10.1007/s11665-018-3240-y
Abstract: The aim of the present study is to develop thermally sprayable WC-12Co and WC-12Co-xAl2O3 (x = 10 and 15 wt.%) cermet coatings on steel substrate (SS 304) by high-velocity oxy fuel (HVOF) method. Influence of Al2O3 addition on… read more here.
Keywords: wear corrosion; cermet coating; 12co al2o3; corrosion ... See more keywords
Cr3C2-25NiCr Cermet Coating: Preparation, PTFE Sealant, Wear and Corrosion Resistances
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Thermal Spray Technology"
DOI: 10.1007/s11666-021-01155-5
Abstract: In this study, Cr3C2-25NiCr cermet coatings were fabricated by atmospheric plasma spraying on 304 stainless steel substrate. Then, the coatings were sealed with a Polytetrafluoroethylene (PTFE) emulsion by using two methods: conventional impregnation and ultrasonic… read more here.
Keywords: wear corrosion; ptfe; 25nicr cermet; cr3c2 25nicr ... See more keywords
Nanostructured TaC film deposited by reactive magnetron sputtering: Influence of gas concentration on structural, mechanical, wear and corrosion properties
Sign Up to like & getrecommendations! Published in 2019 at "Ceramics International"
DOI: 10.1016/j.ceramint.2019.01.055
Abstract: Abstract TaC coatings were applied on the surface of the AISI316L stainless steel by reactive magnetron sputtering, and the effects of CH 4 concentrations ( C CH 4 = 0 , 5 , 10 ,… read more here.
Keywords: reactive magnetron; wear corrosion; structural mechanical; mechanical wear ... See more keywords
Characteristics, wear and corrosion properties of borided pure titanium by pack boriding near α → β phase transition temperature
Sign Up to like & getrecommendations! Published in 2020 at "Ceramics International"
DOI: 10.1016/j.ceramint.2020.03.197
Abstract: Abstract The boride layer characteristics, wear and corrosion properties of borided commercially pure titanium by pack boriding near the α → β phase transition temperature were investigated using X-ray diffraction, scanning electron microscopy, electron probe… read more here.
Keywords: wear corrosion; temperature; phase transition; corrosion ... See more keywords
Microstructural, electrochemical and wear-corrosion characterization of TC4-5Cu alloy fabricated by selective laser melting
Sign Up to like & getrecommendations! Published in 2021 at "Journal of Alloys and Compounds"
DOI: 10.1016/j.jallcom.2021.159953
Abstract: Abstract Additive manufacturing TC4-5Cu alloy has huge potential application prospects in the field of biomedicine. In this paper, the TC4-5Cu alloys with potential for biomedical applications under different laser energy densities were successfully prepared using… read more here.
Keywords: wear corrosion; laser; corrosion; tc4 5cu ... See more keywords
Synergistic interactions between wear and corrosion of Ti-16Mo orthopedic alloy
Sign Up to like & getrecommendations! Published in 2020 at "Journal of materials research and technology"
DOI: 10.1016/j.jmrt.2020.06.095
Abstract: Abstract In this study, corrosion, wear, and tribocorrosion of Ti-16Mo alloy manufactured by powder metallurgy (PM) in phosphate-buffered saline are investigated. The results indicate that the corrosion rate of Ti-16Mo alloy increases about 100 times… read more here.
Keywords: wear corrosion; alloy; synergistic interactions; 16mo alloy ... See more keywords
Wear and corrosion resistant performance of thermal-sprayed Fe-based amorphous coatings: A review
Sign Up to like & getrecommendations! Published in 2019 at "Surface and Coatings Technology"
DOI: 10.1016/j.surfcoat.2019.124896
Abstract: Abstract Thermal sprayed Fe-based amorphous coatings exhibit excellent wear and corrosion resistance, and thus have been widely utilized for enhancing the performance of material surfaces. In this paper, important research progresses achieved in regards to… read more here.
Keywords: thermal sprayed; amorphous coatings; wear corrosion; sprayed based ... See more keywords
Design of wear and corrosion resistant FeNi-graphite composites by laser cladding
Sign Up to like & getrecommendations! Published in 2019 at "Surface and Coatings Technology"
DOI: 10.1016/j.surfcoat.2019.124897
Abstract: Abstract Friction and wear can cause severe surface damage of machine elements and result in their complete failure. Of the several ways to limit/control friction and wear, a measure to counter the potential damage is… read more here.
Keywords: wear corrosion; resistance; friction; graphite ... See more keywords
Atomic Cross-Talk at the Interface: Enhanced Lubricity and Wear and Corrosion Resistance in Sub 2 nm Hybrid Overcoats via Strengthened Interface Chemistry.
Sign Up to like & getrecommendations! Published in 2022 at "Nano letters"
DOI: 10.1021/acs.nanolett.2c02239
Abstract: Friction, wear, and corrosion remain the major causes of premature failure of diverse systems including hard-disk drives (HDDs). To enhance the areal density of HDDs beyond 1 Tb/in2, the necessary low friction and high wear… read more here.
Keywords: chemistry; wear corrosion; interface; hybrid overcoats ... See more keywords
A comparative study on wear and corrosion behaviour of HVOF- and HVAF-sprayed WC–10Co–4Cr coatings
Sign Up to like & getrecommendations! Published in 2017 at "Surface Engineering"
DOI: 10.1080/02670844.2016.1218194
Abstract: In this work, WC–10Co–4Cr coatings were separately deposited on 300M steel by high-velocity oxygen fuel (HVOF) and high-velocity air fuel (HVAF) spraying processes. Microstructure, porosity, micro-hardness, bonding strength, wear and corrosion resistance of the coatings… read more here.
Keywords: wear corrosion; sprayed 10co; 10co 4cr; 4cr coatings ... See more keywords
Evaluation of wear and corrosion resistances of laser cladding TaC/TiC/Stellite X-40 Co-based composite coatings on copper surface
Sign Up to like & getrecommendations! Published in 2021 at "Materials Technology"
DOI: 10.1080/10667857.2021.1913318
Abstract: The TaC/TiC/Stellite X-40 Co-based composite coatings with different contents were successfully cladded on a Cr-Zr-Cu alloy substrate. The microstructure, wear and corrosion resistance of the compo... read more here.
Keywords: tac tic; wear corrosion; stellite based; based composite ... See more keywords